Operation Manual

3. On the side of the doorbell is the SD card slot. Remove the rubber seal and insert the SD
card, then push the rubber seal back into place.
4. Slide the doorbell back into its aluminium case and replace the 3x securing screws.
5. Push the power cable through the hole of the rubber seal.
6. Connect the power cable to the V+ and V- connections at the back of the doorbell.
7. Connect the red wire to the V+ terminal. Connect the black wire to the V- terminal.
Don’t replace rubber seal yet. Plug in the power supply and connect it to the power cable, then
switch the socket on.
8. After around 30 seconds, the red and green LED’s will begin to light up on the back
9. of the doorbell. If this does not happen, please ensure the power cable and the power supply
are all connected correctly and the plug socket is turned on. Push the rubber seal back into
place