Instructions

6 | System operation
14 CMS-30100_IM
Illustration22: Altering the volume
6.2.7 Auto Close
Illustration23: Auto close
Illustration24: Auto close (time out)
duration
The auto close function enables/disables the screen time out. When the auto close
function is enabled, it turns off the monitor screen after a set time while the system is
running in normal operation.
a) From the main menu: Select “System Setup”.
b) Select “Auto Close”
c) Select a duration before time out (the duration starts after the last interaction
with the monitor).
Note: If the monitor is running on batteries, it is recommended to have a short time
out duration to save power.
6.3 Add a camera
Illustration25: Main menu - Add
Camera
Illustration26: Add Camera
The monitor can pair up to 4 cameras. To add a camera do the following procedure:
a) Turn the camera on by connecting it to the mains supply.
b) Wait for 30 seconds.
c) You will now hear “Start configuration mode”.
ð NOTE: If you do not hear the voice, press the re-set button on the camera for
6 seconds until you hear “Restore factory settings”.
d) On the monitor from the main menu: Select “Add Camera”.
e) Select “Add Camera”. (This must be done within x minutes from resetting the cam-
era.)
f) On the camera: If the above steps are done correctly, you will hear:
- “Wireless settings, please wait”
- “Wireless connection successful”
g) On the monitor: Wait for the pairing to complete.