User manual

Figure 4.26 UPnP Settings
【Enable】Highlight ■ to enable the UPnP function. Settings can only be activated after Enable is
ticked;
【HTTP】：Router will automatically assign a port number to the device. Need to enter the port number
to start an IE browser
【TCP】：
Router will automatically assign a port number to the device. Monitoring using client
software will go through this port
【MobilePort】：Router will automatically assign a port number to the device. Mobile monitoring is
implemented through this port
【W IFI】
DVR connect to wireless router via W IFI module, then to visit it through IP address, the precondition
of using this function is to make sure the DVR have connected with W IFI modern.
Pic 4.27 W IFI
configure
Page 45