User manual

Step 15: You will get a confirmation that it is learned succesfull. When it is
already connected, you will get the message that it is already known. Now you
do the same for the Motion Sensor and the Magnetic Contact Sensor.
All connected devices are shown in the screen.
The main Unit is called Internal Siren
Step 16: Decide where you want to mount you main unit! We advice
to mount it out of sight, so that in case of burglary it wil not easy be found! You
need to connect the internet (LAN) cable and plug in the adaptor! Use
the template paper to mark the positions of the screws on the wall.
Leave the screw head protruding for about 7mm so it can push the
tamper switch (on the back of the Gateway) into place.
Step 17: Install Motion Sensors and Magnetic Contact Sensors on the place you
think they are the most effective! Montion Sensors secure a complete Area of
110° x 10 meter. Install in the rooms which are attractive fur the burglar a
Motion Sensor. Don't point the Sensor to windows or heathers! When a Motion
Sensor registers Motion it will give a signal to the main unit. Magnetic
Contact Sensors secures one door or window. Install on the doors or windows
which are interesting for the burglar a Magnetic Contact Sensor.
When a door or window is opened, it will give a signal to the main unit.
Advice: We advice to make a drawing of your home and mark the burglary
sensitive points with a red arrow!
When you have done this you are going to fill in where you want to install
motion- and magnetic sensors! When you have filled in all sensors, you mark
them if you want them active at night, or only when you are out. We advise to
install also minimum a indoor siren, on a strategic place. I case of burglary
everybody in the house must be warned. Depending on the neighbour-hood it is
also wise to install a outdoor siren! They are all wireless, so easy to install. If you
live with more persons in one house, or doesn't like to take the remote, or open
the app everytime to activate or deactivate the system, then we advice to add a
keypad! You can give per person a code, so you can always see who activated or
deactivated the system! For total security of your home you also can add; smoke-
and waterdetectors and a connected to your alarmsystem Internet camera!