User manual

ManualsBrandsSMARTWARES ManualsWireless Alarm SystemsWireless alarm kit Alarm zones (CB) 30

Welcome in world of our Smart Home Wireless Alarmsystem HA701IP

We will guide you during the installationtrip; step by step! The trip will start with

unpacking, sorting, screwing and downloading, and will be accompanied by

screenshots, so that you see what you get!

We wish you a pleasant trip!

Step 1: Unpack all the products and sort them on the table!

Step 2: Write down the Access Code information of the back of the Gateway, on

this field of the manual:

________-________-________-________

The Code is needed for system login. Open the battery compartment at the back

side and install 6 x 1,5 V AA, close it again, plug in the internet (LAN) cable and

the adaptor (POWER) in the contacts at the back. Plug the other side of the

internetcable in your router, and the adaptor in a powersocket.

Step 3: Remove the insulating films on the back of the Motion Sensor and

Magnetic Contact Sensor. Remove the insulating films on the side of remote.

Step 4: Open on your computer again: www.mysecurity.smartwares.eu

Click on "CREATE A NEW ACCOUNT"

Summary of content (8 pages)

PAGE 1
Welcome in world of our Smart Home Wireless Alarmsystem HA701IP We will guide you during the installationtrip; step by step! The trip will start with unpacking, sorting, screwing and downloading, and will be accompanied by screenshots, so that you see what you get! We wish you a pleasant trip! Step 1: Unpack all the products and sort them on the table! Step 2: Write down the Access Code information of the back of the Gateway, on this field of the manual: ________-________-________-________ The Code is neede
PAGE 2
Step5: Confirm your country. Fill in your email adress which will also be your accountname. Fill in the password you want to use for this account. Confirm the password. Click on Submit Step 6: You are now in System Registration: a gateway is found on your network! Fill in the code and click on NEXT STEP Step 7: The system will congratulate you, and askes which name you want to give your system.
PAGE 3
Step 8: The software of you system aske for a update; click on "START UPGRADE" Step 9: Congratulations: Your system is connected and up to date: Click on "TERMINATE" Step 10: You are in the main menu of the system! Step 11: Connect and check the Motion Sensor, Magnetic Sensor and Remote! Click on "System"
PAGE 4
Step 12: We will now add the Sensors and the Remote! Click on "+ add a new device" Step 13: Select the device you want to add, for example Remote, and click on it.
PAGE 5
Step 15: You will get a confirmation that it is learned succesfull. When it is already connected, you will get the message that it is already known. Now you do the same for the Motion Sensor and the Magnetic Contact Sensor. All connected devices are shown in the screen.
PAGE 6
motion sensor magnetic sensor keypad indoor siren outdoor siren smoke detector water detector always always out always sleep always sleep important: The PIR/Motion sensor has a battery saving mode! This means that the Motion Sensor is always ready for triggering.
PAGE 7
Step 19: Click on: "Acount" Step 20: Here you can fill in, if you want, your personal data Step 21: Close the account, and click on: "Security" Here you can define which detectors has to be armed in which mode! You have the opportunity to arm all detectors, or partial! For example: When you are at home you only arm the Magnet contacts on the outdoor. When you are goiing to sleep, you arm also the Motion sensors in the living, and the kitchen, but not upstairs.
PAGE 8
Step 25: If you want to install more Smartalarms, or control! You can add here the other Smartalarms or remove.