Product Specs

Hearing
Sounds
Changing
Mode
Volume
(Up/Down)
Charging
Alarm
Connect an earphone to the audio jack to hear sounds through
the product in real time. Use the SKEEPER app to save and
analyze the measurement results and share them through SNS.
There are three modes: General (heart), lung, and fetus. The
product’s default setting is the general (heart) mode. The mode
is converted in order of fetus, general (heart) and lung. Short
press the Multi-Function Button on the center of SKEEPER to
change the mode.
Volume changes are noted with a short beep through the
earphone and two beeps indicate the volume has reached its
maximum or minimum.
Battery
Warning
Red battery LED flickers and battery warning sound is heard
through the earphone.
Charge the product using the provided USB charging cable. Red
LED is turned on during charging and Green LED is turned on
when fully charged.
Function Operating Methods
BASIC FUNCTION
SKEEPER USE METHOD
MEASUREMENT
SKEEPER USE METHOD
General (Heart) Mode Measurement
General (heart) mode is for measuring general heart sounds. Refer to fetus mode for
fetal heart sound measurement.
➊ Place and turn on the product.
➋ Set the product to general (heart) mode (See below figure).
➌ Lightly press the “diaphragm” of the product to a location near heart.
➍ Press the App’s “Start Button” (on each of Auscultation pages)
and measure for 1 minute or 30 seconds.
Put the Skeeper’s
diaphragm on the Heart
and press gently.
Press the App’s “start button”
and measure for one minute.
If you want to stop in
midstream, please press
the same posotion again.
Lung Mode Measurement
Lung mode is for measuring human body’s breathing sounds or movement sound
of intestine.
➊ Place the product and connect it with an earphone/headset.
➋ Set the product to lung mode.
➌ Lightly press the “diaphragm” of the product to an area under the left and right
clavicle or under the left or right armpit and then breathe in and out deeply.
※ Currently, lung mode app is not supported but will be applied later.
2928