User's Manual

SCMB100 User Manual Rev 1.2

PRIVATE AND CONFIDENTIAL

Page 7

WARNING! As an Original Equipment Manufacturer (OEM) you must ensure that FCC labeling

requirements are met. You must include a clearly visible label on the outside of the final product

enclosure that displays the following content:

Contains FCC ID: 2ATZ3-SCMB100

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1.) this device may not cause harmful interference and (2.) this device must accept any interference

received, including interference that may cause undesired operation.

FCC notices

IMPORTANT: This module been certified by the FCC for use with other products without any further

certification (as per FCC section 2.1091). Modifications not expressly approved by SmartSense by Digi

could void the user's authority to operate the equipment.

IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section 15.107 &

15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.

IMPORTANT: This module has been certified for remote and base radio applications. If the module will

be used for portable applications, the device must undergo SAR testing. This equipment has been tested

and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures: Re-orient or relocate the receiving antenna, Increase the separation

between the equipment and receiver, Connect equipment and receiver to outlets on different circuits,

or Consult the dealer or an experienced radio/TV technician for help.

FCC approved antennas

This module can be installed using antennas and cables constructed with non-standard connectors

(RPSMA, RPTNC, etc.) An adapter cable may be necessary to attach the module connector to the

antenna connector.

The modules are FCC approved for fixed base station and mobile applications for the channels indicated

in the tables below. If the antenna is mounted at least 20 cm (7.87 in) from nearby persons, the

application is considered a mobile application. Antennas not listed in the table must be tested to comply

with FCC Section 15.203 (Unique Antenna Connectors) and Section 15.247 (Emissions).

The antennas listed below have been approved for use with this module: