Instruction Manual

13 14
Wireless Remote Sensor:
—Select a same channel with the weather station for the remote
sensor. Open the battery compartment of the remote sensor to
select channel with numbered knobs (1, 2, and 3).
—Insert 2 x AA batteries in the remote sensor. The indicator
will light up once to indicate that the wireless remote sensor is
sending out signals. Please ensure that the weather station is in
synchronization mode so that it can receive the signals sending
from the remote sensor.
—When the weather station successfully receives signals from
the remote sensor, the temperature and humidity detected by the
remote sensor will display on "OUTDOOR" column of the weather
station.
—The weather station can connect up to 3 wireless remote sensors
at the same time. If multiple sensors are used simultaneously,
please repeat
9.1 Weather Station and Remote Sensor Pairing
to connect other remote sensors. Please make sure these sensors
are on different channels.
—Press "
" button on the weather station to view the readings of
each channel.
9.2 Loop Mode
This mode is applicable in the event that multiple wireless remote
sensors are used simultaneously.
— Press "
" button on the weather station until " " is displaying
in the top left corner of outdoor temperature area. In this mode, the
outdoor readings will display from CH1 to CH3 automatically every
5 seconds.
—To see the temperature and humidity on a fixed channel, just
press "
" button until " " disappears. Once it disappears, the
outdoor readings will stop cycling.
9.3 Manual Signal Reception
If there is no outdoor temperature showing on weather station or
there is no change in the temperature and humidity for a long time,
it indicates that the weather station fails to receive signals from
wireless remote sensor, please take the following operations:
—Please ensure that the channels of the weather station and
sensor are same.
—Long press "SENSOR" button on the back of the weather station
to receive signals manually. A flashing RF antenna symbol will
display beside the channel. This means that the weather station is
in a receiving state.
—Press "TX" button on wireless remote sensor to send out signals
manually and a red light will ash.
Note:
●
In the case of using only one sensor, when the channel of the
weather station is not same as the channel of the sensor, there
would be no outside temperature showing on the weather station.
●
The wireless sensor can be placed anywhere (indoor or outdoor)
you want to measure the temperature remotely.