Instruction Manual

11 12
●
Press and hold "
" key for two seconds, the hour of alarm 1
starts to ash.
●
Press "▲" or "▼" keys to set the required hour.
●
Press "
" to conrm your setting.
●
The minute of alarm 1 starts to ash. Press "▲" or "▼" to set the
required minute.
●
Press "
" to conrm your setting.
●
The hour of alarm 2 starts to ash. Press "▲" or "▼" to set the
required hour.
●
Press "
" to conrm your setting.
●
The minute of alarm 2 starts to ash. Press "▲" or "▼" to set the
required minute.
●
Press "
" to save and complete the setup.
8.4 Turn off the Alarm Tone
The alarm will ring for 2 minutes, pressing any button except
"SNOOZE/LIGHT" will stop the tone. The alarm will repeat at the
same time the next day.
8.5 Snooze Function
Proceed as follows to activate snooze function.
9.1 Weather Station and Remote Sensor Pairing
Weather station:
—Connect the weather station to power supply.
—Select a channel that permanently displays on the weather
station. Press " " button to select CH1, CH2 or CH3.
—After the weather station is powered on, the RF signal icon
located on the upper left side of the "OUTDOOR" column
will flash for 3 minutes. This indicates that the weather station
is in synchronization mode and waiting for the remote sensor to
connect.
—If the RF signal icon
stops ashing after 3 minutes, long press
"SENSOR" button on the back of the weather station to activate the
weather station synchronization mode. The RF signal icon will
ash again.
●
While the alarm is ringing, touch "SNOOZE/LIGHT" to activate
the snooze function. When the snooze function is activated, "
"
or "
" will keep ashing on the display. The alarm will ring again in
5 minutes.
●
When the snooze function is activated, press any button except
"SNOOZE/LIGHT" to exit the snooze mode.
●
If alarm 2 rings during the snooze mode of alarm 1, the snooze
function of alarm 1 will automatically be deactivated.
Note:
During the setup of the alarms, if there is no operation of buttons
within 20 seconds, the weather station will save the current setting
and automatically return to normal display from manual setting
mode.
9. Weather Station and Remote Sensor
Pairing & Manual Signal Reception