Instruction Manual

C1: Temperature
C2: Humidity
C3: Transmission signal light
C4: "°C/°F" button
C5: "TX" button
C6: Channel switch knob
C7: Battery compartment
C8: Hanging hole
C9: Wall-mount hole
6. Preparation
●
Open weather station battery compartment cover, insert 2 x
AA batteries, ensure correct battery polarities [ "+" and "–" ]. And
connect the DC adapter to power the weather station.
●
The screen will light up, and the device will make a beeping
sound. The weather station starts to detect indoor temperature and
humidity.
●
The receiver will start to make a connection with the outdoor
remote sensor, a reception RF antenna symbol in the "OUT"
display area will icker on the screen. This procedure will takes 3
minutes at most.
●
Open the wireless remote sensor battery compartment cover.
Choose a same channel as the weather station. Insert 2 x AA
batteries, ensure correct battery polarities [ "+" and "–" ].
●
After the unit has made a connection with the outdoor remote
sensor, the detected temperature and humidity will display on the
screen.
●
For specic pairing operation of the weather station and remote
sensor, please refer to
9.1 Weather Station and Remote Sensor
Pairing
on page 12.
87
5.3 Wireless Remote Sensor