Installation Guide

4
INSTALLATION
Tools
• Flat-head Screwdriver
• Channel Lock Pliers or Adjustable Wrench
• Allen Key (included)
• Teflon Tape
Guidelines for Positioning
• Install the filter system 1.5 feet below the pool water level.
• Install the filter system on a level, firm surface.
• The filter system should be far enough from the pool as to not be used as a
means to access the pool.
• Ensure there is adequate space provided around the filter system for
operation, maintenance and winterization.
Motor and Base Plate Assembly
1) Install the Strainer Basket (21) and Seat the Large O-Ring (18) in the front
intake port of the Pump Motor (15) as shown in Figure 1.
2)
Place the Clear Cover (19) on top of the intake and secure with the Seal Ring
(20) as shown in Figure 2.
3) Install the Small O-Ring (17) into the Clear Cover (19) and thread in one of
the Barbed Connection (16) as show in Figures 3 and 4.
4) Install the Medium O-Ring (14) into the channel of the center outlet port of
the pump motor and thread in the second Barbed Connection (16) as show
in Figures 5 and 6.
5) Insert the two Mounting Bolts (27) into the bottom of the Base Plate (9), fit
the Pump Motor (15) over the bolts and secure with the Wing Nut, Locking
Washer and Round Washer (24,25 and 26) as shown in Figure 7.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure6
Figure 7