User's Manual

Installation
1. Take top seat cap of pool off and
remove the screws holding one end
of the top seat
2. Lift up one end of the top seat of pool
3. Hang the sensor tube onto the guide
rail. Back of the sensor unit should
rest against the inside of pool wall.
4. For wider guide rail, move the stain-
less bracket forward by removing the three
stainless steel screws and moving the
bracket.
5. Tighten the set screws on the stainless
steel mounting bracket against the pool
wall after inserting the plastic spacer to
protect wall
and liners.
6. Replace the
top seat
and top
cap.
For guide rail
up to 1.2î wide
For guide rail
up to 3/4î wide
Move
f
orwar
d
1
2
3
4
4
5
6