- SmartPool Inc. Swimming Pool Gate Alarm User Manual

RF (radio frequency) signal link testing
This unit provides a convenient RF link test, to ensure good RF
transmission without setting off the alarm.
Hit the
TEST button and hold for a couple of seconds. The unit will
sound one beep or five consecutive beeps. This will depend on
whether the unit is set to ON or OFF. Continue to hold this
TEST
button for three seconds until you hear three consecutive beeps.
The unit will send out a RF alarm signal
to the receiver inside the house without
setting itself off.
The receiver inside the house should sound
within ten seconds after this three
consecutive beeps. If the receiver does
not ring, move the receiver to another
location and check the installation again.
Ensure all
POOLEYE devices are set to
the same channel. (Refer to channel A/
B select of both pool side alarm
transmitter and receiver).
IMPORANT NOTES:
Remember to check the RF link periodically to ensure good RF
transmission. If the RF signal is weak, replace the battery in
the pool side alarm with a new one.
RF signal can be transmitted through a solid wall. However, it is
possible that this may weaken the RF signal. To avoid this, it
is important to place the receiver in a straight line of sight to
the transmitter whenever possible.
The microprocessor (built in the transmitter) is programmed to
make three attempts to send the encoded RF signal out to the
receiver. If the first attempt fails, the transmitter will change
the coding and make a second attempt. If it fails again, the
transmitter will change the coding and try for the third time.
As a result, you may experience a few seconds delay between
setting off the pool side alarm transmitter to the receiver.
Battery level affects RF signal strength. Weak battery in the pool
side alarm transmitter will give weak RF signal out.