User Manual

7
Use
After connecting to a
power supply, press
" " button to power
on. Upon initial startup,
the purifier will operate
in "Auto" mode. For
subsequent startups,
it will operate in such
mode that it is shut
down previously.
Press " " button to set shutdown time in advance.
1
Press " " button to set a mode for the purifier.
2
3
Press " " button to turn the purifier off.
4
Note:
After the timer is activated, the indicator will illuminate. Available
time intervals are displayed as follows, "0h, 1h, 2h, 4h, and 8h". If 0h
is selected, the timer will be canceled.
To cancel the timer, press " " button until the timing indicator is
off and "0h" is displayed on the screen.
Once the timer runs out, the purifier will shut down automatically.
Upon startup, the purifier will not have a time setting for shutdown.
The timer will start again only if it has been reset.
CL
1h
2h
3h
4h
Note:
When "Auto" mode is selected, " " will be illuminated on the screen,
and the purifier will adjust the purification level automatically based
on the IAQ.
In "Custom" mode, settings may be adjusted after connecting to
the Smartmi app and adding a device. By default, the purifier can
operate at full capacity in this mode, resulting in slightly noisier
operation but superior results.
After the purifier has been activated, purification levels may be
adjusted at any time.