User's Manual
Set-top box SmartLabs SML-5041W1. User Manual
● If a storm is coming or if you are not going to use the STB for a long time, unplug the power cord and
disconnect the Ethernet cable. This will help to protect the unit from lightning and power line surges.
● Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or
the like.
● Adapter shall be installed near the equipment and shall be easily accessible.
● The mains plug of adapter is used to disconnect the device from the power supply. The mains plug of adapter
shall remain readily operable.
● When using the STB with a plasma TV, do not pause the playback for more than 5 minutes, due to plasma TV
screen design it could lead to display damage. The STB manufacturer is not responsible for any damage
caused in such manner.
● The software on your STB is updated automatically. Do not unplug the power cord and do not disconnect the
Ethernet cable while the software is updating. The STB manufacturer is not liable for any consequences of
incorrect software update.
● Do not connect the USB port of STB with the USB port of a computer or any other USB power supply. It could
lead to STB damage.
● The manufacturer does not guarantee the absence of interference with other devices. To eliminate possible
interference, increase the distance between the STB and other equipment, or connect equipment using a
different setup.
● The device is going to be operated in the 5150 to 5250 MHz frequency range. It is restricted only to indoor
use.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Battery Information
ISO 7000-0434 (2004-01)
WARNING: Refer to the battery disposal and safety information before replacing the battery.
Do not charge batteries that are not designed for this.
If the batteries are not used correctly, liquid may leak out of them. Avoid contact with this liquid. In
case of accidental contact with the skin, rinse immediately with a large amount of water. If liquid gets into eyes, seek
medical help immediately. Liquid leaking from batteries can cause skin irritation or burns.
Keep batteries away from fire. Do not attempt to disassemble the batteries. Do not cause them to short circuit.
Batteries should be stored at room temperature. Observe the battery polarity when installing.
Keep the batteries out of excessive dynamic exposure, heat, and contact with water or other liquids.
Do not install old and new batteries at the same time, as well as different types of batteries: alkaline, zinc-carbon, or
rechargeable.
Do not ingest the battery, chemical Burn Hazard.
The remote control can be supplied with a coin/button cell battery. If the coin/button cell battery is swallowed, it can
cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the
product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of
the body, seek immediate medical attention.
If fluid from the battery comes into contact with skin or clothing, immediately flush the affected area with clear water.
– 3 –