User's Manual
Table Of Contents
- Thank you for Choosing us
- Distribution Kit
- Safety and Storage
- Indicators and Slots
- Connecting
- Installation
- Connecting to Internet via Wi-Fi
- Remote Control
- Remote Control Setup
- Automatic Setup
- Setting up Remote Control by Using Manufacturer Number
- Table of Manufacturer Numbers and Codes
- Setting up Remote Control by Using a Manufacturer Code
- Controlling Volume of STB or TV
- Changing STB Code
- Resetting the Remote Control
- First Start
- Troubleshooting
- Cleaning
- Disposal
- WEEE Compliance Statement
- Specifications
- Licensing and Certification
- EC Declaration of Conformity
- FCC Compliance Statement
- Innovation, Science and Economic Development (ISED) Canada Compliance Notice
- Manufacture date
- About the Manufacturers
- Warranty
– 8 –
The remote control is supplied with a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children. If you think batteries might
have been swallowed or placed inside any part of the body, seek immediate medical
attention.
If fluid from the battery comes into contact with skin or clothing, immediately flush the affected
area with clear water.
CAUTION: There is a risk of explosion if the battery is replaced by an incorrect type. Dispose
of used batteries according to the instruction in this manual.
Remote Control Setup
The universal remote control can simultaneously work with multiple devices.
To pair the IR remote control with a TV set, you need to perform simple configuring that
will not take much of your time. The RC can be set up automatically as well as manually
using the TV manufacturer’s number or code.
You do not need to perform any special configuring to pair the RC with the TV. For more
information see the section RC Setup.
Automatic Setup
1. Turn your TV on.
2. Point the remote control at your TV. Press and hold the TV and OK buttons for 3
seconds. The LED on the remote control will flash twice and the remote control will
switch to setup mode. Release the TV and OK buttons.
3. Press and hold the CH- or CH+ button. The remote control will automatically send a
Power off code to the TV every 1.5 seconds. When the TV turns off, quickly release
the CH- or CH+ button and press OK to save the code. After that, the LED will blink
twice and the remote control will exit the setup mode.
Setting up Remote Control by Using Manufacturer Number
1. Turn your TV on.
2. Point the remote control at your TV. Press and hold for three seconds the TV button
and the button corresponding to the manufacturer’s number from the table below.
The LED on the remote control will flash twice and the remote control will switch to
the setup mode. Release the TV and OK buttons.
3. Press and hold the CH+ or CH- button. The remote control will automatically send a
Power off code to the TV every 1.5 seconds. When the TV turns off, quickly release
the CH- or CH+ button and press OK to save the code. After that, the LED will blink
twice and the remote control will exit the setup mode.