User's Manual
Table Of Contents
- Thank you for Choosing us
- Distribution Kit
- Safety and Storage
- Indicators and Slots
- Connecting
- Installation
- Connecting to Internet via Wi-Fi
- Remote Control
- Remote Control Setup
- Automatic Setup
- Setting up Remote Control by Using Manufacturer Number
- Table of Manufacturer Numbers and Codes
- Setting up Remote Control by Using a Manufacturer Code
- Controlling Volume of STB or TV
- Changing STB Code
- Resetting the Remote Control
- First Start
- Troubleshooting
- Cleaning
- Disposal
- WEEE Compliance Statement
- Specifications
- Licensing and Certification
- EC Declaration of Conformity
- FCC Compliance Statement
- Innovation, Science and Economic Development (ISED) Canada Compliance Notice
- Manufacture date
- About the Manufacturers
- Warranty
– 5 –
Connecting
Installation
1. Remove your STB from packaging and remove the protective tape.
2. Make sure that the place, where you are installing the STB, meets the following
requirements:
• Place STB on a flat surface.
• Do not place the STB on slick surfaces, where there is a risk of vibration, fall or
other damages of STB.
• Do not mount the STB on soft surfaces, like a bed, carpet, etc. Such a surface
impedes access for air and normal ventilation of the STB and thereby causes
overheating and malfunctioning.
• Do not cover the STB.
• Do not shield the ventilation holes in the STB’s enclosure located at the top
panel of the STB.
• When mounting the STB, make sure that there are at least 10 cm of free space
at each side of the device. Do not place STB in closed cupboards and caves.
• Install and operate the STB with a minimum distance of 20 cm (7.8 inches)
between the device and the body.
• Do not place STB on surfaces, which can heat, for instance, on boosters.
• Do not place any things on the device.
• To avoid damage of the power adapter’s cable, place the cable so that it is not
pressed, pinched or mechanically affected in any way.
3. Make sure that the TV set and the STB are not connected to the power network.
Connect the TV set and the STB with the HDMI cable.
4. Connect the Ethernet cable to the STB. If you a going to use the Wi-Fi connection skip
this step.
5. Connect the STB and the TV set to the power network.