Booklet

STOPS SHORT
D
H
G
F
E
Scroll to RIGHT TURN . Press ENTER. You should
see a flashing number. Write this number here: ____
Set the Rover on the floor. Use masking tape to mark
the starting location or just line it up with a straight
edge. Tile flooring works great!
Repeat the process from steps E to G with the LEFT
TURN
. Write the flashing number here: _______
When your RECON 6.0 executes a full circle to the
left, press SAVE.
Press SAVE again to return to the Start Screen.
Press ENTER and watch your Rover turn in a circle.
• If the rotation is a full 360°, go to step H.
• If the rotation is short of 360°, scroll up to the next
number using the UP ARROW. Realign your Rover.
Press ENTER.
• If the rotation overshot 360°, scroll down to the next
number using the DOWN ARROW. Realign your Rover.
Press ENTER.
Keep adjusting the number up or down—one digit
at a time—until your Rover performs a circle to your
satisfaction.
When you find the number that works best (returning
your Rover to its starting point), press SAVE.
Using the arrows on the directional pad, scroll to DRIVE
REVERSE
and press ENTER. Your Rover should
drive in reverse 3 feet and stop.
CREDIBLE INTELLIGENCE
A full circle is 360º. This is made up of four 90º segments.
Visualize the points on a compass.
Your Rover counts rotations of its drive wheel using a number
that measures the rotations needed to achieve a turn. You may
have to adjust the number until your Rover performs a full
circle, ending at the starting point.
STRAIGHT
EDGE
OVERSHOOTSFULL CIRCLE
90°
180°
270°
7
360°