Use and Care Manual

3-2
CAUTION:
TO PREVENT TOOL AND ACCESSORY FAILURE,
RESULTING IN INJURY: DO NOT EXCEED THE TOOL’S 90
PSI AIR PRESSURE RATING.
3.3 Air Drill
1. The Drill attachment is designed to work with drill bits ranging from 1/16”
to 15/64”. Ten are included in the case: 1/16”, 5/64”, 3/32”, 7/64”, 1/8”,
9/64”, 5/32”, 11/64”, 3/16”, and 1/4”
2. Before installing a bit into the chuck, make sure that the tool’s trigger is
in the locked (OFF) position.
3. Slide selected bit into chuck. Use the chuck key (turning
counterclockwise) if the chuck needs to be opened more to
accommodate bit.
4. Use the chuck key (turning clockwise) to secure bit firmly into chuck.
Ensure that the bit stays in a straight upright position. If the bit is
crooked and not upright it will not secure properly in chuck.
5. DO NOT attempt to install a drill bit that exceeds the 3/8” chuck
capacity.
6. Mark the area you wish to drill with a center punch (not included).
7. Gently squeeze the trigger to tighten or loosen bolt/nut. Apply additional
pressure on trigger as needed.
8. Drill only as deep as necessary. DO NOT drill into walls without first
verifying there are no hidden utility wires or hazards behind drilling
surface.
9. When hole is drilled, remove drill bit from hole while the tool is still
spinning. This will prevent the bit from getting caught in the hole and
causing damage. If the bit does get caught immediately release trigger.
WARNING!
DO NOT TOUCH chuck or drill bit while the drill attachment is
still running.
WARNING!
DO NOT attempt to remove drill bit immediately after drilling.
Allow bit to cool before attempting to remove.