Use and Care Manual

2-3
3. Align hex drive in body to hex drive of attachment. Slide end of
attachment into body and release attachment release ring.
4. To lock the attachment in place, turn the attachment release ring so that
the pin is no longer aligned with the pin.
CAUTION:
THERE IS A RISK OF THE ATTACHMENT BEING
ACCIDENTALLY RELEASED DURING OPERATION IF THE
ATTACHMENT RELEASE RING IS NOT TURNED SO THAT
THE NOTCH AND PIN ARE NO LONGER ALIGNED.
5. To remove attachments, turn the attachment release ring to realign the
notch and pin and pull back on the ring towards the trigger. Once the
attachment is released, remove the attachment from the tool body.
6. Unused attachments should be kept in the provided case to keep them
clean and protected.
2.4 Connecting to Air Supply
WARNING!
TO PREVENT EXPLOSION: USE ONLY CLEAN, DRY,
REGULATED, COMPRESSED AIR TO POWER THIS TOOL.
DO NOT USE OXYGEN, CARBON, DIOXIDE,
COMBUSTIBLE GASES, OR ANY OTHER BOTTLED GAS
AS A POWER SOURCE FOR THIS TOOL.
Note:
If an automatic oiler system is not used, add a few drops of
pneumatic/air too oil to the air line connection before operation.
Add a few more drops after each hour of use.
CAUTION:
IF YOU ARE WORKING WITH AN AIR HOSE THAT IS NOT
“SELF-COILING”, ROUTE THE AIR HOSE ALONG A SAFE
ROUTE TO REACH THE WORK AREA WITHOUT
CREATING A TRIPPING HAZARD OR EXPOSING IT TO
POSSIBLE DAMAGE.