MSDS

2
SECTION 4
FIRST AID MEASURES
Swallowing: If patient is fully conscious, give two glasses of water, induce vomiting.
Obtain medical attention.
Eye contact: Flush eyes with water for at least 15 minutes. Obtain medical assistance
if discomfort persists.
SECTION 5
Fire and Explosion Data
Flash Point: >120º F., 49º C
Pensky-Martens Closed Cup - ASTM D93
Auto ignition temperature: 450 º C E1491
Extinguishing Method: Carbon dioxide, dry chemical foam
SECTION 6
ACCIDENTAL RELEASE MEASURES
Large spills: Eliminate all ignition sources; ground all equipment; do not walk through
spill;stop spill if possible; prevent entry into sewers, confined spaces, etc.; use a vapor
suppressing foam to reduce vapors; absorb spill with non-combustible matter and transfer
to containers; use non-sparking tools to collect absorbed material.
Take up with sand or oil
absorbing materials. Carefully shovel, scoop or sweep up into a waste container for
reclamation or disposal - caution, flammable vapors may accumulate in closed containers.
Response and clean-up crews must be properly trained and must utilize proper protective
equipment.
SECTION 7
HANDLING AND STORAGE
• Combustible material - keep away from heat, sparks, and flame; sudden releases of hot
organic vapors or mists from process equipment operating at elevated temperature may
result in ignitions without the presence of obvious ignition sources.
• Avoid contact with eyes.
• Keep container closed.
• Use with adequate ventilation.
• Ground container when transferring product.
• Vapors may collect in containers; treat empty containers as hazardous.
• Wash thoroughly after handling
• Vapors may settle in low or confined areas
Disposal: Dispose of according to Federal, state and/or local regulations
Precautions to be Taken in Handling and Storing: Avoid open flames
Other Precautions: None