Use and Care Manual

USER’S MANUAL PAGE 26TECH-5000P

USING THE Air Pump

• Connect the air hose to the air pump by screwing the hose into

the end of the

hose (part A in figure 4), do not use protective cap (part B in

figure 4) for screwing as it is only for the protection of overheat.

Air Pump. When screwing, use main body of the

• Connect the other end of the air hose to the valve stem of the

balls including soccer, basketballs and footballs.

NOTE:

bursts and check after each burst by feel or with a calibrated

measuring device to determine accurate pressure. Pressure

required for most sports balls is too low for accurate reading on

tool gauge.

• Power on the air pump (choose an option mentioned in previous

section).

• The manufacturer preset pressure is 30 PSI and this air pump

has memory function. The gauge will indicate unites and value.

• Press “SET” button to choose the desired unit (PSI, BAR, KPA,

kg/cm ). See Fig. 5.

• Press “-” or “+” button to choose the desired value. Press and

hold “-” or “+” button will accelerate numerical change. After

system will enter the chosen unit.

• Press the air pump’s On/Off button to start and hold this button

for continuous running. And the built-in LED light is lit during

inflation.

•

the Lock/Unlock switch upwards to lock while the On/Off button

is pressed. In

any button. To stop the inflation, simply press the On/Off button.

• When the desired pressure is reached, the air pump will stop

running as it has pre-set function. when the desired pressure

The air pump has switch lock function. If needed, you can turn