Use and Care Manual

USER GUIDE PAGE 10JS-15000N USER GUIDE PAGE 11JS-15000N
LIMITED WARRANTY
Effective April 15, 2017. Replaces all undated warranties and all warranties
dated before April 15, 2017
w
Repair/Replacement Warranty
Smartech Products warrants to the original purchaser that the mechanical
and electrical components will be free of defects in material and workmanship
for a period of one (1) year from the original date of purchase. This product is
intended for household use only. Transportation charges on product submitted
for repair or replacement under this warranty are the sole responsibility of
the purchaser. This workmanship for a period of warranty only applies to the
original purchaser and is not transferable.
Do not return the unit to the place of purchase.
Contact Smartech Products’ Customer Service and Smartech Products will
troubleshoot any issue via phone or e-mail. If the problem is not corrected
by this method, Smartech Products will, at its option, authorize evaluation,
3) Fully charge the unit.
4) When charging is complete, unplug the AC charging adapter from the
wall socket rst, then from the charging jack on the jump starter.
DC Charging in Your Vehicle:
1) Turn the vehicle engine on.
2) Insert the DC charging adapter into the charging jack of the unit.
3) Plug the other end of DC charging adapter into vehicle’s cigarette
lighter socket.
4) Fully charge the unit. Engine must keep running during entire charge.
5) When charging is completed, unplug the DC charging adapter from
the vehicle rst, then from the charging jack on the jump starter.
USB Charging:
This product has a USB cable that can also be used to recharge the
jump starter.
Charging Time:
LCD will show “100%” as fully charged. Charging time will differ based on the
discharge level and the power source used. If charging begins from 5% to
full charge, it approximately takes approxiamately 7 hours for AC charging
USB POWER
Connect the USB device to the jump starter with either the original cable or
the included multi-tip cable (better use original cable of Apple® for Apple®
products). Press Power button to start USB power. When disconnected,
the jump starter will automatically shut off. The number of times you can
recharge a USB device will vary between devices.
FLASHLIGHT
Press and hold Power button for 3 seconds to start ashlight. Press once to
switch lighting modes: Steady On – Strobe – SOS – Off.
SUPPLY TO 19V DEVICES
Select the appropriate input tip and connect the jump starter with your lap-
top. Press the Power button to start 19V/3.5A power. When disconnected,
the jump starter will automatically shut off. The number of times you can
rechaerge a laptop will vary between decives.
SUPPLY TO 12V DEVICES
The jump starter can run/charge 12VDC appliances that draw 10 amps or
less.
Two options as follows:
1) Connect the jump starter to 12V devices with the optional accessory
(This item does not include the accessory). Press Power button to start 12V
power. When disconnected, the jump starter will automatically shut off.
2) Connect the jump starter to 12V devices by the incuded accessory.
You do not need to press the Power button as the EC5 12VDC output is
ALWAYS activated. When the battery voltage of the jump starter is too low,
12V devices will stop running/charging.