Users Manual Part 2

When the setup is done, you can start processing materials. Prepare a material you would like
to work on. (Measure the thickness of the material because you need to input the thickness of
the material in the software later.)
Check that the Etcher Laser’s power is on.
Connecting the Etcher Laser to PC
Use the USB cable enclosed with the device to connect the Etcher Laser to your PC. DO NOT
use a USB hub and directly connect the devices.
Launch the software and place the material
Launch the software and start. When you launch the software for the first time, follow the
instructions on the application window to fill in the settings.
When the Etcher Laser and PC are properly connected, the software will show “Connected”
on the top left side of the screen.