User Manual

4 in 1 Multi sensor
User manual
Rev. 1 del 30.11.2022
Pag. 5 a 6
www.myvirtuosohome.com/en/downloads ).
1. Press and hold the pairing button for 5 seconds until the LED turns on, then release it before it turns
off.
2. The blue LED will flash at 1 second intervals until inclusion is successful.
Note: When the device is in inclusion mode, all features are disabled.
Exclusion
Before starting the procedure for including the device in a Z-Wave network, make sure that the MyVirtuoso
Home gateway is in exclusion mode (refer to the relevant manual available on the website
www.myvirtuosohome.com/en/downloads ).
1. Press and hold the pairing button. present above the batteries, for 5 seconds until the LED lights up,
then release it before it turns off.
2. The blue LED will flash at intervals of 0.5 seconds until the exclusion is successful.
Reset
1. Make sure the device is powered.
2. Press the pairing button for 10 seconds until the LED turns pink. Release the button before it goes out.
Note: This procedure will erase all data from the device (including home ID, node ID, etc.) and restore factory
settings. Use this procedure only when the gateway is missing or not functional.