User Manual

4 in 1 Multi sensor
User manual
Rev. 1 del 30.11.2022
Pag. 4 a 6
Specification
Battery
2 CR123A, MicroUSB Type B batteries
Protocol
Z-Wave
Communication range
30m in open field
Detection distance
12 m
Detection angle
120°
Temperature detection
0-40 ° C
Humidity detection
0-85%
Brightness detection
0-3.000 Lux
Tamper
Yes
Protection
IP21
Fixing
with dowels or double-sided tape
Frequency
868.42 MHz
Operating humidity
< 95% (not condensed)
Dimension
45 (A) x 45 (L) x 48 (P) mm
Package content
• Multisensor.
• Double-sided tape.
• Screws (x2).
• Micro USB power cable.
• User manual
Installation
1. Remove the back cover by unscrewing it and insert 2 CR123A batteries making sure the polarity is
correct. Then close the lid only after you have included the device in the Z-Wave network.
If you want to power the device via the supplied Micro USB cable, you will need to insert it into the
appropriate slot.
Note: The MultiSensor can also be powered by a single CR123A battery. In this case it will have to be changed
more frequently than inserting two batteries (average life of 1 year). If you intend to proceed, insert a CR123A
into the slot marked with the number 1.
Inclusion
Before starting the procedure for including the device in a Z-Wave network, make sure that the MyVirtuoso
Home gateway is in inclusion mode (refer to the relevant manual available on the website