Use and Care Guide

Technical Service Bulletin No. 523 2/19 | 2/3
4. Repeat steps #2 and #3, if necessary.
When the resilient flooring is cleaned properly, the floor will have the same visual as right
out of the box!
PREVENTATIVE MAINTENANCE
 Always protect floors when moving heavy objects to prevent permanent scratches and tears.
The use of Ram Board or similar protection and heavy cardboard are examples of protective
barriers.
 Use appropriate wide floor protectors under tables, chairs, and any other heavy home
furnishing to avoid permanent damage.
 Walk-off mats should be used at all entrances to absorb soil and moisture. If mats are placed
directly on top of the resilient floors, use mats without latex or rubber backings to avoid
possible discoloration.
 Use appropriate window coverings to avoid direct sunlight as this can fade the color of the
flooring.
ROUTINE MAINTENANCE
 Daily removal of dirt and dust is important to prevent particles from abrading the surface of
resilient floors. Sweeping, dust mopping, and vacuuming are recommendations to remove
soil particles that can result in scratches and worn appearances. Do not use vacuums with
rotating beater bars on hard surfaces.
 Periodic wet cleaning will be necessary to help maintain the floor’s appearance. Always pre-
vacuum or dust mop before any type of wet cleaning. Appropriate vinyl floor cleaning
equipment and cleaning agents (neutral pH floor cleaners) are recommended. Do not use
abrasive cleaners or cleaning agents that leave dull residues on the surface of the floors.
Follow the cleaning manufacturer’s instructions for damp mopping and application. If rinsing
is necessary, use clean water and expedite drying with air movers or fans.
 Encore, COREtec neutral pH floor cleaner or equivalent floor cleaner are recommended for
general spotting and cleaning.
 Avoid using mop and shine products on your resilient flooring.
SPOT & SPILL REMOVAL
Our flooring products are engineered to resist and minimize common staining.
 Absorb wet spills as quickly as possible by blotting with paper or cloth towels. Rinse with
water if necessary and blot dry.
 Dried spots should be removed by gentle agitation and rinsed with water. Blot dry.
 Use Encore, COREtec cleaning products or products formulated for vinyl floor cleaning. Do
not use detergents or abrasive cleaners since these products can leave a dull residue.