Installation Guide
Installation
4. Installation of the product must start from the left side of the room, workingto the right when working in front of the flooring or
facing the starting wall. Use spacers along the walls to maintain proper expansion space (1/4”) andalign the first piece.
5. Install the secondrow by aligning and dropping the end tongue over the end groove of the first piece. Apply light pressure to join
the two piecestogether.
6. If needed use a rubber mallet to fully engage the short side of the flooring by lightly tapping on the top of the flooring to engage
and sit flush with the adjacent piece. Maintain an expansion gap of approximately 1/4” from the wall. Repeat this process to
complete the first row. If the end is raised use a non-marking rubber mallet to lightly tap the end (tongue side) about 1” from the
seam. Do NOT tap directly on the seam.
7. Start the second row by cutting the flooring to the desired length. Keep in mind thatpiece must not be shorter than 6" (15cm)
to achieve the best appearance.
4
For reference purposes only if printed or downloaded.