Installation Guide
Fire Manual Call Point
Installation Guide
Part number Product description
SC-51-0100-0001-99 Fire Manual Call Point
1 Pre installation
2 Components
!
Installation must conform to applicable local installation codes and
should only be installed by a fully trained competent person.
This device contains electronics that may be susceptible to damage
from Electrostatic Discharge (ESD). Take appropriate precautions
when handling electronic boards.
The use of a non-metallic spacer should be considered if mounting
the device on to a metal surface.
Fit the breakable tag aer installation and testing of the device.
4 Fix mounting plate
When fixing to the wall, all four fixing positions must be used to ensure a
firm fixing.
Use suitable fasteners and
fixings.
60 mm
60 mm
OBSERVE
ORIENTATION!
60 mm
2x alternative fixing positions
are also available for fixing to
existing electrical mounting
boxes
(Alternative
fixing positions)
Observe the orientation
marking as shown.
3 Remove mounting plate
Carefully unclip the two sections, observing the hinged connection at the top
of the device.
2x ER14505M
LITHIUM 3.6V
5 Fit batteries
When fitting / replacing batteries, observe correct polarity, using only
specified batteries.
OBSERVE BATTERY
POLARITY!
!
6 Configuration
The device must now be added (programmed) to the control panel.
Device powering
Method 1
Magnet application
Method 2
Via computer
Method 3
©2021 EMS Ltd. All rights reserved. Page 1 of 2 TSD087-0001-99 (Issue 3) 25/08/2021 AJM
Transparent cover
1
Mounting plate
3
Allen key
4
Reset key
5
Fire manual call point
2
Breakable tags
6
7
Batteries (Not included in some regions*).
2
3
54
1
6 7
*When batteries are not supplied, only fit specified batteries.
To ensure correct operation, products must be used within the
specified environmental operating conditions.
Refer to the programming manual
for full programming details.
SmartCell panel = TSD155
SmartCell WZM = MK067