Owners manual

FRONT PANEL CONTROL

To switch ports using the front panel, press the M1 or M2 button to navigate between connected com-

puters. EDID learning is also done through the front panel buttons by pressing both buttons simultane-

ously.

Figure 6-1

HOTKEY COMMANDS

The Hotkey command is a keyboard sequence used to trigger an action on the D2H-4P Quad through the

use of the keyboard connected on the USB port of the D2H-4P Quad. To activate the hotkey sequence,

press the CTRL key twice and then enter the desired hotkey commands. See Table 6-2.

Table 6-2

COMMANDS HOTKEYS RS-232 CONTROL

Switch all devices (KVM, USB 2.0, and

Audio)

[CTRL] [CTRL] m [port #] [ENTER] //m [port #] [ENTER]

Switch KVM only [CTRL] [CTRL] c [port #] [ENTER] //c [port #] [ENTER]

Switch USB 2.0 only [CTRL] [CTRL] u [port #] [ENTER] //u [port #] [ENTER]

EDID Learning [CTRL] [CTRL] e [ENTER] //e [ENTER]

Same as front panel ◄ M1 button [CTRL] [CTRL] ↑ n/a

Same as front panel M2 ► button [CTRL] [CTRL] ↓ n/a

Reset [CTRL] [CTRL] r //r

Factory Default Reset [CTRL] [CTRL] f //f

Switch Audio only [CTRL] [CTRL] a [port #] [ENTER] //a [port #] [ENTER]