User's Guide

21
3. Configuration
Restoring the default values
The following are the default values of the SAG-1010 (in AP mode). You can restore the default
values by pressing the reset button for more than five seconds.
Parameter Default value
Wireless Interface
SSID ………………………………………………………... AP_XXXXXX
Response to broadcast SSID requests …………………. Enabled
Channel …………………………………………………….. Channel 1
Operation mode …………………………………………… Mixed
Transmit Rate ……………………………………………… Auto
Preamble …………………………………………………… Long
Authentication Method ……………………………………. Open system
or Shared Key
Encryption ………………………………………………….. None
Ethernet Interface
Enable DHCP ……………………………………………… No(Disabled)
IP Address …………………………………………………. 192.168.1.1
Subnet Mask ………………………………………………. 255.255.255.0
Default Gateway …………………………………………... Blank
Access Control
Accept association requests from any station
…………
Enabled