User's Guide

27
4. Using the device
4.3 Replacing cable connections of other devices
You can also use the SAG-1010 to replace your Xbox, PlayStation
®
2, or set-top box network
cable connection. To do this:
1. Switch the SAG-1010 to Ethernet adapter mode using the mode switch. (Default SSID: ANY)
2. Place the SAG-1010 nearest the AP you wish to connect, then turn on the device.
3. Connect one end of the supplied RJ-45 cable to the Ethernet port of the device and the other
end to the Xbox, PlayStation® 2, or set-top box Ethernet port.
4. Set the IP address of the Xbox, PlayStation® 2, or set-top box to establish connection to the
local network. Verify your connection.
Make sure the SAG-1010 MAC cloning feature is enabled when using the device in this
setup. Use the Wireless Setting Utility to enable MAC cloning. See page 3-24 for details
on MAC cloning.
4.4 Sharing Internet connection with other PCs
Refer to the typical network configuration below and a table on the next page for information on
Internet connection sharing with other computers in your office or home network.
Use the mode switch to set the SAG-1010 to AP mode before sharing an Internet
connection with other computers in your network.
Table 4-1: Internet connection sharing matrix
If your Internet
connection is
Then set the IP of other
computer(s)
Number of allowed Internet
connections
xDSL
1
with dynamic
IP account)
ISP automatically assigns the IP
(using PPPoE dial-UP)
Depends on the Internet(PPPoE
2
Service Provider (ISP)
xDSL with static OP To the provided static IP Service
Provider (ISP)
Depends on the Internet
xDSL/Cable with a
enable DHCP
3
server
The DHCP server automatically
assigns the IP
Depends on the DHCP router and
server, usually about 253
Internet
ADSL/Cable modem Wireless computer