User's Manual

SmartAnt 47
4.3 Replacingcableconnectionsofotherdevices
You ca n also use the SAA04-05224A to replace y our Xbox, PlayS tation
®
2, or set-top box network cable connection. To do this:
1. Switch the SAA04-05224A to Ethernet adapter mode using the mode
switch. (Default SSID: ANY)
2. Pl a ce the SAA 04-05224A ne arest the AP y ou wish to conne ct, then turn
on the device.
3. Connect one end of the supplied RJ-45 cable to the Ethernet port of the
device a nd the other end to the Xbox, PlayS tation
®
2, or set-top box
Ethernet port.
4. Set the IP address of the Xbox, PlayStation
®
2, or set-top box to establish
connection to the local network. V erify y our connection.
Make sure the SAA04-05224A MAC cloning feature is enabled when
using the de vice in this setup. Use the W irel ess Setting Utility to
enable MAC cloning. See page 3-24 for details on MAC cloning.
4. 4 Shar ing Inte rnet conne cti on with other PCs
Refer to the typical netw ork configuration below and a ta ble on the next page for
inform ation on Internet connection sharing with other computers in your office
or home network.
WirelesscomputerInternet

ADSL/Cable modem
Use the mode switch to set the SAA04-05224A to AP mode before
sharing an Internet connection with other computers in your network.
Ta ble 4-1: Internet connection sharing matrix
1
xDSL ¡C ADSL (Asym met ric Digit al Subs criber Line) or DSL (Digital Subsc riber Line)
2
PPPo E ¡CPoint-to-Point over Ethernet
3
DHCP ¡CDynamic Host C onfiguration Protocol
If your Internet Then set the IP of Number of allowed
connection is other computer(s) Internet connections
xDSL
1
with dynami c IP ISP automatically assigns Depends on the Internet (PPPoE
2
account ) the IP (using PPPoE dial-up) Service Provider (ISP)
xDSL with static IP to the provided static IP Depends on the Internet
Service Provider (ISP)
xDSL/Cable with a The DHCP server Depends on the DHCP router and
enable DHCP
3
server automatically assigns the IP server, usually about 253
4. Using the device