Product Information
10 SmartAC.com Hardware Kit - Product Information
Medical conditions
If you have a medical condition that you believe could be affected by using SmartAC.com
devices (for example, seizures, blackouts, eyestrain, or headaches), consult with your
physician prior to using SmartAC.com devices.
Explosive and other atmospheric conditions
Using SmartAC.com devices in any area with a potentially explosive atmosphere, such
as areas where the air contains high levels of flammable chemicals, vapors, or particles
(such as grain, dust, or metal powders), may be hazardous. Exposing SmartAC.com
devices to environments having high concentrations of industrial chemicals, including
near evaporating liqueed gasses such as helium, may damage or impair the device’s
functionality. Obey all signs, and instructions.
Regulatory Compliance Information
FCC Compliance and Exposure to Radio Frequency Information
The radiated output power of the Wi-Fi technology is below the FCC radio frequency
exposure limits. Nevertheless, it is advised to use the wireless equipment in such a
manner that the potential for human contact during normal operation is minimized.
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during device
operation. To ensure compliance, operations at closer than this distance are not
recommended.
This device complies with Part 15 of the FCC Rules / Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Les règles établies par Federal Communications Commission / Idustry Canada RF
demandent que les antennes installées doivent être situées de façon à ce que les
personnes y tiennent toujours une distance d’au moins 20 cm lorsque l’appareil est en
marche.. Pour être certain que ce standard soit respecté, nous ne recommandons donc
pas l’utilisation den notre appareil avec une distance inférieure à 20cm entre l’antenne et
des personnes.
Le présent appareil est conforme aux CNR d’Industrie Canada pour les appareils radio
exemptés de licence. L’utilisation est donc autorisée aux deux conditions suivantes
: (1) l’appareil ne doit pas produire de brouillage dérangeant d’autres appareils, et (2)
l’appareil doit accepter tout brouillage radioélectrique dérangeant subi, même si le cela est
susceptible d’en compromettre le fonctionnement.
Radio and Television Interference
This equipment generates, uses, and can radiate radio-frequency energy. If it is not
installed and used properly—that is, in strict accordance with SmartAC.com instructions—
it may cause interference with radio and television reception.
This equipment has been tested and found to comply with the limits for a Class B digital
device in accordance with the specications in Part 15 of FCC rules. These specications
are designed to provide reasonable protection against such interference in a residential
installation. However, there is no guarantee that interference will not occur in a particular
installation.
You can determine whether your SmartAC.com devices are causing interference by
turning them off (removing power). If the interference stops, it was probably caused by the
SmartAC.com device or one of its peripheral devices. If your SmartAC.com Hardware Kit