User`s guide

4. Do any of the following:
o
To move the 3D model on the screen, move the cube.
o
To rotate the 3D model on the screen, rotate the cube in your hand.
o
To unassign the 3D model from the cube, cover the cube’s markings with your hand.
N O T E
If you experience any of the following symptoms, the cause may be issues with tracking:
o
The 3D model doesn’t connect to the cube.
o
The 3D model shakes when it’s connected to the cube.
o
The 3D model sporadically disconnects from the cube.
o
SMARTNotebook software enters Mixed Reality mode when the cube is under the
camera even if you aren’t moving the cube.
To address tracking issues, see Lighting requirements on page 62.
T I P S
o
As you move and rotate the cube in your hand, ensure you don’t cover the symbols on the
cube’s surface.
o
To hide the image from the SMARTDocumentCamera and show only the 3D model,
move the transparency slider to the left.
5. If you’ve purchased a second cube from SMART and there is more than one 3D model on the
page, manipulate another 3D model by completing steps 3 and 4 with the other cube.
N O T E
The two cubes must have different patterns if you want to use them both at the same time.
6. When you’re done, move the cube (or cubes) away from the camera.
SMARTNotebook software exits Mixed Reality mode after a few seconds.
Disguising 3D models before presenting them
If you want to hide 3D models in your .notebook file before presenting them, you can use the Disguise
feature to hide the 3D models with a magic hat.
When you use Mixed Reality Tools, the magic hat disappears after Mixed Reality Tools assigns the
3D model to the cube, revealing the 3D model.
C H A P T E R 7
Using 3DTools for SMARTNotebook software and Mixed Reality Tools
71