Operation Manual

Note to this document
4 ENG Smart MX 04 L
Adjusting of the ZF canals and frequency
Ö Switch on the receiver.
Ö Press the button
on the remote control
Ö Press the
and the button, select "installation" and confirm
with the
button.
Ö Enter the password (in the state of delivery 0000 is pre-installed).
The installation menu is indicated.
Ö Select the Menu point "antenna setup".
Ö Select the menu point "LNB frequency" after this, select "unicable (9750-
10600)".
Ö Select the menu point "IF Channel" enter a ZF channel.
Ö (Begin with channel "1"; one of the ZF channels in climbing up order
assign to the connected receivers).
Ö Choose "Center Freq" and set up the frequency (see the allocation table)
Ö The bargraph “signal strength” and “signal quality” will display
immediately, when the correct frequency is chosen.
Ö Press the
button
Ö The adjustments are saved.
You are back in the „Installation menu“
Ö Press the button
twice.
The receiver is into the normal mode and ready to receipt.