User manual

Aligning the Antenna
32 smart Mobile Sat System
Figure 12: Adjusting of the azimuth angle of the satellite antenna
4.
From this starting position, turn the antenna gradually to the left towards the east.
5.
After each step, you have to wait about 4 to 5 seconds and check if an image appears on
the connected TV set. The satellite receiver always needs a short time to receive a signal
from the data stream.
6.
Once you have an image of the set channel, please consult the user manual of the re-
ceiver on the fine tuning of the antenna.
If you do not get an image after rotation of the satellite antenna through 90 degrees, do the
following:
7.
Turn the satellite antenna back to the south.
8.
Change the angle of elevation by 1 degree up.
9.
From this starting position, turn the antenna gradually to the left towards the east.
10.
After each step, you have to wait about 4 to 5 seconds and check if an image appears on
the connected TV set. The satellite receiver always needs a short time to receive a signal
from the data stream.
11.
Once you have an image of the set channel, please consult the user manual of the re-
ceiver on the fine tuning of the antenna.
12.
If you do not get an image after rotation of the satellite antenna through 90 degrees,
repeat steps 7 to 9 until you have corrected the elevation angle by 5 degrees.
13.
If you still do not get an image, rotate the dish back to the south and set the angle speci-
fied for your location in the azimuth and elevation tables on the pages 33 and 34.
14.
Change the angle of elevation by 1 degree down.
15.
From this starting position, turn the antenna gradually to the left towards the east.
16.
After each step, you have to wait about 4 to 5 seconds and check if an image appears on
the connected TV set. The satellite receiver always needs a short time to receive a signal
from the data stream.