User manual

Connecting the Devices
30 smart Mobile Sat System
Turn the F connector on the backwarded wire
mesh until the insulation touches inside the F-
connector.
Cut the inner conductor, until it protrudes not
more than 1mm beyond the F connector.
Figure 9: Mounting of the F-connector on the coaxial cable
9 Connecting the Devices
Attention!
First, connect the receiver and the antenna using a suitable cable
with each other before you connect the receiver to the mains or a
car battery. Otherwise, the receiver can be destroyed and will void
the warranty.
Please also read the manual of the receiver carefully.
1.
Connect your receiver to the antenna and to your TV. For more information on connecting
the receiver, refer to its manual.
2.
Connect the coaxial cable to the LNB.

The two F-connectors are screwed to the receiver and to the LNB
only by hand. Do not use tools and avoid tilting!
1.
Connect your receiver to the mains or to the car battery.
2.
Turn on your TV set.
3.
Turn on your receiver. On the screen during the startup phase you will see a welcome
screen. If this is not the case, you must set your TV to AV mode.
4.
Follow the instructions on the screen until the configuration of the receiver is finished.
1 mm