User manual

6
6. Installation (Getting started)
Please read this manual before installing the receiver
Place the receiver close to a TV-set or any other home devices to connect them together using the cables available
in the set. The following important rules must be followed:
- Do not place the receiver close to heat sources.
- Do not place the receiver close to radio waves emitting devices (e.g. mobile phones)
- Place the receiver in the direct access of the remote control
- All plug connection must be done before receiver plugged in to mains power outlet
6.1. Connecting receiver to Antenna, TV Set, Multichannel Audio System
6.1.1. Connecting to satellite and terrestrial antenna
Fig. 4 Connecting to antennas, network and TV
Skyter 3D HD is equipped with two independent DVB-S/S2 inputs LNB A and LNB B accordingly. Depending on your
satellite dish installation, you can use single, dual/twin LNB & cable or Unicable (TM) configuration. In case you have
twin LNB and cable installation or Unicable (TM), each tuner can select any satellite signal independently. In case of
single cable LNB connection to LNB A input, signal for both tuners loops internally. The type of satellite dish
installation is selected in MENU>Settings>System settings>Antenna setup>Satellite LNB configuration>LNB
connected. See Fig. 5.