User manual

9
Fig. 9 Adding a new satellite
6.1.3. Terrestrial antenna setup
Terrestrial antenna is connected to RF IN input. If your antenna is equipped with the amplifier (the so-called active
antenna), Skyter 3D HD can supply voltage to power it. It is selected by MENU>Settings>System setting>Antenna
Setup>Terrestrial antenna setup>Antenna power. The supply voltage is 5volt and 100mAmp current. You can
easily install you terrestrial antenna by setting your region transmitter frequency and tune position of antenna by
looking on the signal bar. Press the yellow button to confirm and save you configuration.
6.1.4. Connecting to TV-set and Multichannel Audio System
Two ways are possible for connecting a receiver to a TV-set - with HDMI or with SCART cable.
HDMI is more preferable as it gives you a possibility to get HD quality on a TV screen. By default setting, Skyter 3D
HD will read EDID table of the supported formats from the connected TV-set and install a TV mode accordingly. You
also can adjust this modes manually, but please be careful – some modes can not be supported by your TV-set. In
this case no picture will be available. In this case connect a TV-set with SCART cable (SCART signal is always
available), choose HDMI video menu and set AUTO EDID mode ON. AUTO EDID set ON means that the receiver
reads EDID table from the connected TV-set and set up a resolution. Is the frame rate is the same as the video
content being played, the picture quality will be the best possible. If a video content resolution and frame rate is not
supported by the connected TV-set (no equivalent mode is available on the EDID table read) Skyter 3D HD will
select the nearest possible mode, supported by the connected TV-set.