User manual

6
6. Installation (Getting started)
Please read this manual before installing the receiver
The receiver should be placed close to a TV-set or any other home devices to connect them together using the
cables available in the set. The following important rules must be followed:
- Do not place the receiver close to heat sources.
- Do not place the receiver close to radio waves emitting devices (e.g. mobile phones)
- Place the receiver in the direct access of the remote control.
6.1. Connecting receiver to Antenna, TV Set, Multichannel Audio System
6.1.1. Connecting to satellite and terrestrial antenna
Fig. 4 Connecting to antennas, network and TV
Skyter 3D HD is equipped with two independent DVB-S/S2 inputs LNB A and LNB B accordingly. Depending on your
satellite dish installation, you can use single or dual/twin LNB & cable configuration. In case you have twin LNB and
cable installation, each tuner can select any satellite signal independently. In case of single cable LNB connection to
LNB A input, signal for both tuners loops internally. The type of satellite dish installation is selected in
MENU>Settings>System settings>Antenna setup>Satellite LNB configuration>LNB connected. See Fig. 5.