User manual

Fig. 16 Network connection menu

In case 3G modem is attached to USB port, the PPP(modem) line will appear on the network list. Pls note, that a

modem can be attached only to rear USB ports due to power requirement. Both rear USB ports can supply 1Amp

current and Front USB port can supply only 0.5Amp. By selecting PPP connection you can also scan, connect and

change the available option for 3G/GSM connection. Pls note, that not all types of modems are supported by the

system software. The supported modems are listed on the web site. Press red button to select default connection

route to internet. In case the default connection is available, the receiver will link to internet via this connection. If the

default connection is not available, the receiver will try to link internet via any other available network connection,

LAN is always preferable in this case. Press yellow button to switch OFF WLAN adapter completely. Press green

button to check if the internet connection is available and to see the actual network internet route.

7. Receiver setting up

7.1. Switching on

Plug the receiver into a power outlet. After the advertising screensaver, the installation guide is displayed on the TV

screen. Select menu, language, time zone and the receiver will start the terrestrial channels auto scanning. You can

press EXIT button to stop this dialog. All selections saved during the dialog can be changed later in the main menu.

7.2. Main menu

The main menu includes a lot of settings for the receiver configuration. Press MENU button on the remote control to

enter the main menu. Press  /  buttons for Menu lines selection.. The selected line is highlighted. Press OK

button to enter the selected menu line window. Press MENU button to return back to the previous menu window.

Press EXIT button to exit from the main menu. To enter the settings and recordings sub menu you may select

relevant line and press the right button.