User Manual

Bell Sensing Technologies Training Manual | 87
BELL SENSING APP
In order to service a T-Rex iQ rat
trap and receive the information
from the sensor, you will need to
be inside the range to download
the data. That range is typically
within 5-10 feet of the device.
While in the device list screen, you
will see circles for each device.
When the hollow circle fills in to
become a fully colored circle, you
have reached the “downloadable”
range. After you are inside that
range, you may tap the full circle
to begin the download. This will
only take a few seconds.
SERVICING A T-REX iQ
™
TRAP
Once the information is
downloaded, the screen will
pop up giving you the service
options.
If nothing is captured in
the device, you would tap
“NO CAPTURE”. If something
is captured in the device, you
would tap “CAPTURE”.
Once you tap “CAPTURE”,
next, tap “Capture Type” and
choose what was captured
from the drop-down list and
choose the gender. On this
screen you may choose one
of the “Quick Notes” to
document the conditions of
the trap. Additionally, you
have the ability to document
any custom notes you may
have if needed. However,
this is not mandatory.
Once you have completed
the above steps you would
now tap the blue check in the
bottom right-hand corner.
This concludes the service
of the device. On the device
list you will now see a full
green circle with a check to
indicate the device has been
fully serviced.