Installation Instructions

Adding Device(s) to Account
To add devices to the account tap “Add Device”.
At this screen you can either manually type in the serial number from
the device or you can tap the camera icon. If you tap the camera icon
you will then scan the QR code that is on the device. It will automat-
ically take you back to the “Add the device” screen and will fill in the
serial number for you.
Tap the blue arrow in the bottom right-hand corner.
This will pair the device with the app and will only take a few seconds.
Once the device is found you will want to give the device a name, num-
ber and location description.
Within the location description it’s important to input a concise de-
scription to help locate and know you are at the correct device in the
future.
.
On this screen you have the ability to add any custom notes you may
have if needed. However, this is not mandatory.
When adding a 24/7 or T-Rex tap the blue check in the bottom right-
hand corner twice to finish adding the device to the account.
For an Express Tray there are a few more steps. If you will be baiting
or trapping in an Express Tray tap “Add Bait/T-Rex”.
For baiting, tap on the “Bait Type” and choose the bait you are using.
Next, tap the “Amount Used” section and manually type in the number
used.
For trapping, slide the slider on the left-hand side of “Include T-Rex”
from left to right.
Once you have completed the above steps you would now tap on the
blue check in the bottom right-hand corner. On the “Add the device”
screen that pops up tap on the blue check in the bottom right-hand
corner again. This concludes the adding of the device to the account.