Installation Instructions

Servicing a Trapper® 24/7 Multiple Catch IQ™ trap:
In order to service a Trapper® 24/7 IQ™ trap and receive
the information from the sensor, you will need to be in-
side the range to download the data. That range is typical-
ly within 10-20 feet of the device.
While in the device list screen, you will see circles for each
device. When the hollow circle fills in to become a fully col-
ored circle, you have reached the “downloadable” range. Af-
ter you are inside that range, you may tap the full circle to
begin the download. This will only take a few seconds.
Once the information is downloaded, the screen will pop
up giving you the service options.
If nothing is captured in the device, you would tap “No
Capture”.
If something is captured in the device, you would tap “Cap-
ture”.
Next, tap “Capture Type” and choose what was cap-
tured from the drop-down list, choose the gender, manually
type in the number for “total captures” and tap “Add”.
***You can repeat these steps if there are multiple species
of animals captured.
On both screens you may choose one of the “quick notes”
to document the conditions of the device as well. Addi-
tionally, you have the ability to type in any custom notes if
needed. However, this is not mandatory.
Once you have completed the above steps
you would now tap the blue check in the bottom right-hand
corner. This concludes the service of the device.
On the device list you will now see a fully colored green
circle with a check to indicate the device has been fully
serviced.