Installation Instructions

Servicing an EVO® Express® IQ™ Tray or EVO® Ambush®
IQ™ Tray:
In order to service an IQ™ tray and receive the information
from the sensor, you will need to be inside the range to
download the data. That range is typically within 10-20 feet
of the device.
While in the device list screen, you will see circles for
each device. When the hollow circle fills in to become a
fully colored circle, you have reached the “downloadable”
range. After you are inside that range, you may tap on the
full circle to begin the download. This will only take a few
seconds.
Once the information is downloaded, the screen will pop
up giving you the service options. If you are baiting in the
station, there will be the option to either refill or not re-
fill the bait. If you are trapping in the station, there will be
an option for documenting a capture. If you are doing both,
both options will be displayed.
For Baiting:
When you are not refilling the bait - tap “not refilled”.
When you are refilling the bait - tap “refilled”. To document
the bait type, tap the “Bait Type” and choose the bait you
are using. Next, tap the “Amount Used” section and manu-
ally type in the number used.
For Trapping:
When you are trapping in a station, there will be an option
to document any captures. If something is captured, tap
the “capture” icon. Next, tap “Capture Type” and
choose what was captured from the drop-down list. Final-
ly, choose the gender.
On this screen you may choose one of the “quick notes” to
document the conditions of the station as well. Additionally,
you have the ability to document any custom notes you may
have if needed. However, this is not mandatory.
Once you have completed the above steps
you would now tap the blue check in the bottom right-hand
corner. This concludes the service of the device. On the
device list you will now see a full green circle with a check
to indicate the device has been fully serviced.
PICTURES 154-160