User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
83 smarttech.com/kb/170401
System Information
Various system information.
Command/response definitions
Command Response Powered off
set autosignal [target] autosignal =[current] no
get autosignal autosignal =[current] no
set lampreminder
[target]
lampreminder =
[current]
no
get lampreminder lampreminder =
[current]
no
set highbrightness
[target]
highbrightness =
[current]
no
get highbrightness highbrightness =
[current]
no
set autopoweroff
[target]
autopoweroff =[current] no
get autopoweroff set
zoom [target]
autopoweroff =[current] no
set zoom [target] zoom=[current] no
get zoom zoom=[current] no
set projectorid [target] projectorid =[current] no
get projectorid projectorid =[current] no
set aspectratio [target] aspectratio=[current] no
get aspectratio aspectratio=[current] no
set projectionmode
[target]
projectionmode =
[current]
no
get projectionmode projectionmode =
[current]
no