User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
82 smarttech.com/kb/170401
Field Possible Values Description
target network l on
l off
Enable/Disable network module and VGA output
current dhcp l = on
l = off
Enable/Disable for DHCP Networking
target dhcp l on
l off
Enable/Disable for DHCP Networking
current ipaddr l [?].[?].[?].[?] Current IP address (static or dhcp assigned)
target ipaddr l [?].[?].[?].[?] Set to static IP Address
current subnetmask l [?].[?].[?].[?] Current Subnet Mask
target subnetmask l = [?].[?].[?].[?] Current Subnet Mask
current gateway l [?].[?].[?].[?] Current gateway
target gateway l = [?].[?].[?].[?] Current gateway
current primarydns l [?].[?].[?].[?] Current primary dns
target primarydns l = [?].[?].[?].[?] Current primary dns
MAC address l [?]-[?]-[?]-[?]-[?]-
[?]
The device’s MAC address.