User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
81 smarttech.com/kb/170401
Network information
Various network information.
Command/response definitions
Command Response Powered off
get netstatus netstatus =[current] yes
set network network=[current] yes
get network network=[current] yes
set dhcp [target] dhcp =[current] yes
get dhcp dhcp =[current] yes
set ipaddr [target] ipaddr =[current] yes
get ipaddr ipaddr =[current] yes
set subnetmask
[target]
subnetmask =[current] yes
get subnetmask subnetmask =[current] yes
set gateway [target] gateway =[current] yes
get gateway gateway =[current] yes
set primarydns [target] primarydns =[current] yes
get primarydns primarydns =[current] yes
get macaddr macaddr =[MAC
address]
yes
Field definitions
Field Possible Values Description
current netstatus l connected
l disconnected
Current state of the network interface
current network l on
l off
Current status of the network module and VGA
output