User manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
75 smarttech.com/kb/170401
target brightness l + val
l – val
l = 0 ~ 100
Specifying + or – will cause brightness to be
incremented or decremented from it’s current
value. Specifying a numerical value within the
possible range causes brightness to be set
directly to that value.
current brightness l = 0 ~ 100 The device’s current brightness.
target contrast l + val
l – val
l = 0 ~ 100
Specifying + or – will cause contrast to be
incremented or decremented from it’s current
value. Specifying a numerical value within the
possible range causes contrast to be set directly
to that value.
current contrast l = 0 ~ 100 The device’s current contrast.
target frequency l + val
l – val
l = -5 ~ +5
The ranges must match the OSD ranges
current frequency l = -5 ~ +5 The ranges must match the OSD ranges
target tracking l + val
l – val
l = 0 ~ 31
The ranges must match the OSD ranges
current tracking l = 0 ~ 31 The ranges must match the OSD ranges
target saturation l + val
l – val
l = 0 ~ 100
The ranges must match the OSD ranges
current saturation l = 0 ~ 100 The ranges must match the OSD ranges
target tint l + val
l – val
l = 0 ~ 100
The ranges must match the OSD ranges
current tint l = 0 ~ 100 The ranges must match the OSD ranges
target sharpness l + val
l – val
l = 0 ~ 31
The ranges must match the OSD ranges
current sharpness l = 0 ~ 31 The ranges must match the OSD ranges